Electronics syllabus class 10 SLC Soluti

The solution is comming in near future

Unit-1 Introduction (5 Hours)

1.1 Matter, molecule, and atom

1.2 Electric charges and its quantity, electric current

1.3 Potential difference, difference between electromotive force and potential difference

1.4 Direct current and alternating current

1.5 Basic parameter of alternating current: definition of amplitude, frequency, wavelength, peak to peak

value, root mean square value, average value

1.6 Review on Ohm’s Law and Kirchhoff’s voltage and current laws. `      

Unit-2 Passive Component (8 Hours)

Introduction

Resistor capacitor and inductor are the passive components. They are called the passive components because they can operate without the use of the

2.1 Resistors, construction, types, characteristics, color code

Resistor is the passive

BB ROY of Great Britain has Very Good Wife.

2.2 Capacitors, construction, types, characteristics, color code

2.3 Inductor, construction, types, characteristics, color code

Unit-3 Semiconductor (14 Hours)

3.1. Energy levels, energy bands and conduction of electrons and holes

3.2. Semiconductor materials, characteristics of Germanium and Silicon materials, doping, P type N type

materials, minority and majority carrier

3.3. PN junction, depletion layer, energy barrier potential, Forward and reverse bias, junction

characteristics, effect of temperature, junction capacitance

3.4. Reverse breakdown effects, Avalanche, Zener and Thermal breakdown

3.5. Semiconductor diodes: zener diodes, Light emitting didoes, power diodes, varactor diodes, photo

diodes, characteristics and application

3.6. Solar cells, LDR, Thermostats

Unit-4 Power supplies (5 Hours)

4.1 Basic rectifier circuits, types, working principle, characteristics and applications

4.2 Zener voltage regulator, principle, circuit design and calculation

Unit-5 Bipolar junction transistors (10 Hours)

5.1 Types of transistors, working principles, circuit characteristics and applications

5.2 Biasing methods in transistor and stabilization of operating point, DC load line

5.3 Transistor operation circuits: CB, CE and CC configuration

5.4 Operation of transistor in Saturation and Cutoff region

Unit-6 Special purpose Transistors (4 Hours)

6.1 Unijunction transistor, characteristics and application

6.2 Programmable unijunction transistor

6.3 Photo transistor, characteristics and application

Unit-7 Field Effect Transistor (5 Hours)

7.1 Field effect transistors, types, working principles and characteristics and applications

7.2 MOSFET, types, working principles and characteristics and applications

PRACTICAL

Unit-2 Passive component (12 Hours)

2.1. Measure R, L, C, circuits

Unit-3 Semiconductor (25 Hours)

3.1. Assess Diode characteristics

3.2. Assess Half wave and Full wave rectifier circuits

3.3. Assess Zener voltage regulator

3.4. Use semiconductor manuals (Data sheet)

Unit-5 Bipolar junction transistors (20 Hours)

5.1. Identify transistor characteristics

Unit-7 Field Effect Transistors (20 Hours)

7.1. Assess FET characteristics

Reference Books:

1. M. Tepper Basic Radio Vol. 2 to 5

2. H. Meleaf Basic Electronics Vol. 1 to 7

3. F. Malvino Principles of Electronics